Operation:ptransition; Operation:suppress; Operation[:Event]; Preset - Keysight N5171B EXG Manual

System Commands
Status Subsystem (:STATus)

:OPERation:PTRansition

:STATus:OPERation:PTRansition <value>
:STATus:OPERation:PTRansition?
This command determines which bits in the Standard Operation Condition
Register will set the corresponding bit in the Standard Operation Event
Register when that bit has a positive transition (0 to 1).
The variable <value> is the sum of the decimal values of the bits that you want
to enable.

:OPERation:SUPPress

:STATus:OPERation:SUPPress 0|1|ON|OFF
:STATus:OPERation:SUPPress?
This command disables the instrument's management of the Standard
Operation Condition Register and saves 50 us of switching time.

:OPERation[:EVENt]

This is a destructive read. The data in the register is latched until it is
queried. Once queried, the data is cleared.
:STATus:OPERation[:EVENt]?
This query returns the decimal sum of the bits in the Standard Operation Event
Register.

:PRESet

Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference
Supported All Models
Range 0 to 32767
Remarks Refer to the Programming Guide for more information.
Supported All Models
*RST OFF
Remarks Refer to the Programming Guide for more information.
Supported All Models
Range 0 to 32767
Remarks The equivalent PTR or NTR filters must be set before the
condition register can set the corresponding bit in the
event register.
Refer to the Programming Guide for more information.
Supported All Models
199