Frequency:multiplier; Frequency:offset - Keysight N5171B EXG Manual

Basic Function Commands
Frequency Subsystem ([:SOURce])
To perform a frequency and amplitude sweep, you must also select LIST as
the power mode. See the
amplitude sweep.

:FREQuency:MULTiplier

[:SOURce]:FREQuency:MULTiplier <value>
[:SOURce]:FREQuency:MULTiplier?
This command sets the multiplier for the signal generator carrier frequency.
This displayed frequency equals the actual frequency times the multiplier.

:FREQuency:OFFSet

[:SOURce]:FREQuency:OFFSet <value><unit>
[:SOURce]:FREQuency:OFFSet?
This command sets the frequency offset.
The query of this command returns a value equal to the original output
frequency times the multiplier value, plus the frequency offset value. This
displayed frequency equals the actual frequency times the multiplier.
When an offset has been entered, the OFFS indicator is turned on in the
frequency area of the display.
The frequency offset state is turned on when any non–zero value is entered;
entering zero will turn it off. Refer to the :FREQuency:OFFSet:STATe command
for setting the offset state independent of entering offset values.
76
LIST This choice selects the swept frequency mode. If sweep
triggering is set to immediate along with continuous
sweep mode, executing the command starts the LIST or
STEP frequency sweep.
:MODE
*RST CW
Key Entry Freq
Supported All Models
*RST +1.00000000E+000
Range Negative values: -1000 to -0.001
Positive values: 0.001 to 1000
Key Entry Freq Multiplier
Remarks For any multiplier other than one, the MULT indicator is
shown in the frequency area of the display.
Supported All Models
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference
command for selecting the list mode for an
Freq Off