Connecting Dc-Input Power - Cisco ONS 15540 ESP Hardware Installation Manual

Powering Up the Shelf

Connecting DC-Input Power

Step 1
Step 2
Step 3
Cisco ONS 15540 ESP Hardware Installation Guide
2-34
To apply DC-input power to your Cisco ONS 15540 shelf, follow these steps:
Remove the four screws from the terminal block access panel on the back panel
of the chassis. (See Figure
Figure 2-17 Terminal Block Access Panel
Terminal block
access panel
Remove the insulation of each wire on both ends of the interconnection cables at
a length of about a 1/4 inch (6 mm).
Insert the cord through the power supply cable strain relief on the back left side
of the chassis. (See Figure
Chapter 2
2-17.)
2-18.)
Installing the Cisco ONS 15540
78-15095-01