Dip Switches Sw2 And Sw3 Configuration; Dip Switch Sw2 For Compactpci Interface Configuration; Dip Switch Sw3 For Pmc Interface Configuration; Dip Switches Sw2 And Sw3 - Kontron CP6003-SA User Manual

Configuration
To clear the uEFI BIOS settings, proceed as follows:
1. Set the DIP Switch SW1, switch 4, to the ON position.
2. Apply power to the system.
3. After 30 seconds, remove power from the system.
During this time period of approx. 30 seconds, no messages are displayed.
4. Set the DIP Switch SW1, switch 4 to the OFF position.
4.1.2

DIP Switches SW2 and SW3 Configuration

Figure 4-2: DIP Switches SW2 and SW3
Table 4-2:

DIP Switch SW2 for CompactPCI Interface Configuration

SWITCH 1 SETTING
1
2
Table 4-3:

DIP Switch SW3 for PMC Interface Configuration

SWITCH 1
1
2
The default settings of the DIP switches are indicated by using italic bold.
Page 4 - 4
OFF PCI 33 MHz / 66 MHz auto detection via the CompactPCI backplane
ON PCI frequency configured to 33 MHz
OFF PCI / PCI-X mode auto detection via the CompactPCI backplane
ON CP6003-SA configured to PCI mode
SETTING
OFF PCI / PCI-X frequency multiplier configured to 33 MHz
ON PCI / PCI-X frequency multiplier configured to 25 MHz
OFF PCI / PCI-X mode auto detection via the PMC module
ON PMC interface configured to PCI mode
CP6003-SA
DESCRIPTION
DESCRIPTION
ID 1044-9757, Rev. 2.0