Table of Contents
Advertisement
CP6003-SA
4. Disconnect any interfacing cables that may be connected to the board.
Warning!
The CP6003-SA front panel cables and, when installed, the RIO transition
module front panel cables may have power applied which comes from an
external source.
In addition, these cables may be connected to devices that can be dam-
aged by electrostatic discharging or short-circuiting of pins.
It is the responsibility of the system designer or integrator to ensure that
appropriate measures are taken to preclude damage to the system or inju-
ry to personnel which may arise from the handling of these cables (con-
necting or disconnecting).
Kontron disclaims all liability for damages or injuries resulting from failure
to comply with the above.
5. Unscrew the front panel retaining screws.
Warning!
Due care should be exercised when handling the board due to the fact that
the heat sink can get very hot. Do not touch the heat sink when changing
the board.
6. Using the ejector handles, disengage the board from the backplane and carefully remove
it from the system.
7. Dispose of the "old" board as required observing the safety requirements indicated in
Chapter 3.1.
8. Obtain the replacement CP6003-SA board.
Warning!
When performing the next step, DO NOT push the board into the back-
plane connectors. Use the ejector handles to seat the board into the back-
plane connectors.
9. Carefully insert the "new" board into the "old" board slot until it makes contact with the
backplane connectors.
10. Using both ejector handles, engage the board with the backplane. When the ejector han-
dles are locked, the board is engaged.
11. Fasten the front panel retaining screws.
12. Connect all required interfacing cables to the board.
Hot swap of the CP6003-SA is now complete.
ID 1044-9757, Rev. 2.0
Installation
Page 3 - 7
Advertisement
Table of Contents
