Table of Contents
Advertisement
Introduction
Table 1-1:
CP6003-SA Main Specifications (Continued)
FEATURES
Rear I/O
Gigabit Ethernet
USB
Serial
PMC
XMC
Serial ATA
Page 1 - 12
The following interfaces are routed to the rear I/O connectors J3 and J5.
COMA (RS-232 signaling) and COMB (RS-422 signaling); no buffer on
•
the rear I/O module is necessary
4 x USB 2.0
•
1 x CRT VGA, 2 x HDMI/DVI
•
1 x HDA
•
2 x Gigabit Ethernet (compliant with PICMG 2.16, R 1.0)
•
4 x SATA 3 Gb/s
•
2 x GPIOs (on request)
•
The rear I/O connector J4 is optionally available and provides rear I/O inter-
connection to the PMC/XMC interface.
Five 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on one Intel® 82579LM Gigabit Ethernet controller and one Intel®
82580EB Quad Gigabit Ethernet controller:
Three RJ-45 connectors on the front panel
•
Two ports on the rear I/O (PICMG 2.16)
•
Automatic mode recognition (Auto-Negotiation)
•
Automatic cabling configuration recognition (Auto-MDI/X)
•
Six USB ports supporting UHCI (USB 1.1) and EHCI (USB 2.0):
Two type A USB 2.0 connectors on the front panel
•
Four USB 2.0 ports on the rear I/O interface
•
Two 16C550-compatible UARTs:
One RS-232 port on the front panel and routed to rear I/O, COMA
•
One RS-422 port on the rear I/O, COMB
•
PMC interface:
Four onboard mezzanine connectors, (Jn1-Jn4), for connecting a stan-
•
dard PMC module
Up to 64-bit / 66 MHz PCI or up to 64-bit / 133 MHz PCI-X interface with
•
dedicated PCIe-to-PCI-X bridge
Only 3.3V PCI signaling voltage
•
Rear I/O supported through the CompactPCI connector J4 (optional)
•
Supported voltages: 3.3 V, 5 V, +12 V, and -12 V
•
XMC interface:
One onboard XMC connector (P15)
•
Up to x8 lanes PCI Express 2.0 ports operating at 5 GT/s
•
Rear I/O supported through the PMC connector (Jn4) to the
•
CompactPCI connector J4 (optional)
Two Serial ATA 6 Gb/s interfaces for:
Up to 32 GB flash memory via an onboard SATA Flash module, or
•
Onboard 2.5" hard disk drive (HDD) or solid state drive (SSD) is
•
supported in combination with the MMADP-SATA01 module
One standard SATA 6 Gb/s interface for the standard SATA connector
•
Four SATA 3 Gb/s ports accessible via rear I/O
SPECIFICATIONS
ID 1044-9757, Rev. 2.0
CP6003-SA
Advertisement
Table of Contents
