CP6003-SA
2.10.1.3
General Purpose LEDs
The CP6003-SA provides four General Purpose LEDs (LED0..3) on the front panel. They are
designed to indicate the boot-up POST code after which they are available to the application.
If the LED0..3 are lit red during boot-up, a failure is indicated before the uEFI BIOS has started.
In this case, check the power supply. If the power supply appears to be functional and the LEDs
are still red, please contact Kontron for further assistance.
The POST code is indicated during the boot-up phase. After boot-up, the LEDs indicate Gen-
eral Purpose or Port 80 signals, depending on the uEFI BIOS settings. The default setting after
boot-up is General Purpose.
Table 2-2:
General Purpose LED Function
LED
COLOR
LED3
red
green
amber
LED2
red
green
amber
LED1
red
green
amber
LED0
red
green
amber
Note ...
The bit allocation for Port 80 is the same as for the POST code.
ID 1044-9757, Rev. 2.0
FUNCTION DURING
FUNCTION
DURING BOOT-UP
(if POST code config. is
When lit up during
--
boot-up, it indicates a
power-on reset.
--
uEFI BIOS POST bit 3
and bit 7
--
--
When lit, it indicates a
--
catastrophic CPU error.
--
uEFI BIOS POST bit 2
and bit 6
--
--
When lit up during
--
boot-up, it indicates a
hardware reset.
--
uEFI BIOS POST bit 1
and bit 5
--
--
When lit up during
--
boot-up, it indicates a
uEFI BIOS boot failure.
--
uEFI BIOS POST bit 0
and bit 4
--
--
Functional Description
uEFI BIOS POST
enabled)
General Purpose or Port 80
Default: General Purpose
General Purpose or Port 80
Default: General Purpose
General Purpose or Port 80
Default: General Purpose
General Purpose or Port 80
Default: General Purpose
FUNCTION
AFTER BOOT-UP
Page 2 - 9