Table of Contents
Advertisement
CP6003-SA
Table 1-1:
CP6003-SA Main Specifications (Continued)
FEATURES
Front Panel Connectors
Onboard Connectors
DIP Switches
Reset Switch
Hot Swap Switch
System LEDs
Ethernet LEDs
Watchdog Timer
System Timer
ID 1044-9757, Rev. 2.0
VGA: 15-pin, D-Sub connector, J9
•
USB: two 4-pin, type A connectors, J6 and J7
•
Ethernet: three 8-pin, RJ-45 connectors, J10, J11 and J12
•
Serial port: one 8-pin, RJ-45 connector, J8 (COMA)
•
PMC/XMC front panel bezel cutout
•
PMC connectors J21 - J24 (Jn1 - Jn4)
•
XMC connector, J20
•
Two SATA connectors
•
One 7-pin, standard SATA connector, J14
•
One 34-pin, SATA extension connector, J17
•
JTAG connector, J16
•
Debug connector, J15
•
XDP-SFF (debug) connector, J25
•
CompactPCI Connectors J1 - J5, J4 optional
•
Two 204-pin DDR3 SODIMM sockets, J18 and J19
•
Three onboard DIP switches, SW1, SW2, and SW3, for board configuration
One front panel hardware reset switch
One switch for hot swap purposes integrated in the front panel handle in
accordance with PICMG 2.1 Rev. 2.0.
System Status LEDs:
I0/I1 (red/green):
•
WD (green):
•
TH (red/green):
•
HS (blue):
•
General Purpose LEDs:
LED 0..3 (red/green/amber): General Purpose / POST code
•
Gigabit Ethernet Status on CP6003-SA:
ACT (green):
•
SPEED (green/orange/off):
•
Software-configurable, two-stage Watchdog with programmable timeout
•
ranging from 125 ms to 4096 s in 16 steps
Serves for generating IRQ or hardware reset
•
The Intel® QM67 chipset contains three 8254-style counters which have
•
fixed uses
In addition to the three 8254-style counters, the Intel® QM67 chipset in-
•
cludes eight individual high-precision event timers that may be used by
the operating system. They are implemented as a single counter each
with its own comparator and value register.
SPECIFICATIONS
Indicate the software status of the IPMI
controller
Watchdog Status
Temperature Status
Hot Swap Control
Ethernet Link/Activity
Ethernet Speed
Introduction
Page 1 - 13
Advertisement
Table of Contents
