5-bin mailbox diverter solenoid removal
See"5-bin mailbox assembly (interior)" on page 7-37
1.
Remove the mailbox from the printer.
2.
Remove the 5-bin mailbox feed motor with plate. See
page
4-241.
3.
Remove the four screws (A) securing the diverter plate.
4.
Remove the screw (B) of the deflector gate solenoid you need to remove.
5.
Carefully unroute the deflector gate solenoid cables from the cable clips under the top cover.
6.
Disconnect the appropriate deflector gate solenoid cable from the controller card.
7.
Route the cable through the frame to remove the assembly.
for the part number.
"5-bin mailbox feed motor with plate removal" on
Repair information
5062
Previous
Next
Go Back
4-239