Lenovo System x3630 M4 Installation And Service Manual page 207

Step 5. Install the PCI riser-card assembly in the server (see "Replacing a PCI riser-card assembly" on
page 237).
Step 6. Perform any configuration tasks that are required for the adapter.
Step 7. Install the cover (see "Replacing the server top cover" on page 321).
Step 8. Install the server in the rack cabinet (see the Rack Installation Instructions that come with the
server for instructions).
Step 9. Reconnect the power cord and any cables that you removed.
Step 10. Turn on the peripheral devices and the server.
Removing the CD/DVD cable
Use this information to remove the CD/DVD cable.
To remove the CD/DVD cable, complete the following steps:
Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 36.
Step 2. Turn off the server (see "Turning off the server" on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3. Remove the server top cover (see "Removing the server top cover" on page 320).
Step 4. Remove the PCI riser-card assembly (see "Removing a PCI riser-card assembly" on page 235).
Step 5. Remove the air baffle (see "Removing the air baffle" on page 322).
Step 6. Disconnect the USB, video, CD/DVD and operator information cables from the system board.
Please remember the relevant cable routing.
.
Chapter 6 Removing and replacing components
193