Lenovo System x3630 M4 Installation And Service Manual page 88

Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 36.
Step 2. Turn off the server (see "Turning off the server" on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3. Remove the server top cover (see "Removing the server top cover" on page 39).
Step 4. If you have the optional hot-swap rear hard disk drive cage installed, rotate it up (see "Rotating the
optional hot-swap rear hard disk drive cage up" on page 40).
Step 5. Remove the PCI riser-card assembly (see "Removing a PCI riser-card assembly" on page 41).
Step 6. Remove the air baffle (see "Removing the air baffle" on page 43).
Step 7. Locate the second microprocessor socket on the system board (see "System-board internal
connectors" on page 30)f.
Step 8. Release the microprocessor release lever by pressing down on the end, moving it to the side, and
releasing it to the open (up) position.
Step 9. Open the microprocessor bracket frame by lifting up the tab on the top edge. Keep the bracket
frame in the open position.
Microprocessor
release lever
Attention: Do not touch the connectors on the microprocessor and the microprocessor socket.
Step 10. The microprocessor is preinstalled in the installation tool, release the sides of the cover and remove
the cover from the installation tool.
Step 11. Install the microprocessor:
a. Align the holes on the microprocessor installation tool with the screws on the microprocessor
bracket, then place the microprocessor installation tool down over the microprocessor. Twist
the handle clockwise to attach the tool to the microprocessor.
Alignment
pins
b. Twist the handle on the microprocessor tool counterclockwise to insert the microprocessor
into the socket.
74
Lenovo System x3630 M4 Installation and Service Guide
Microprocessor
bracket frame
Microprocessor
installation tool
(microprocessor
inside)