Table of Contents
Advertisement
Note: IPv6 address will not immediately show on host address when we change the values and have to
exit and re-visit the driver to get the actual value.
Step 1.
Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power, the power-control
button becomes active.
When the prompt <F1> Setup is displayed, pressF1. (This prompt is displayed on the screen for
Step 2.
only a few seconds. You must press F1 quickly.) If you have set both a power-on password and
an administrator password, you must type the administrator password to access the full Setup
utility menu.
Step 3.
From the Setup utility main menu, select System Settings.
Step 4.
On the next screen, select Integrated Management Module.
Step 5.
On the next screen, select Network Configuration.
Step 6.
Find the IP address and write it down.
Step 7.
Exit from the Setup utility.
Logging on to the Web interface
Use this information to log on to the web interface.
To log on to the IMM Web interface, complete the following steps:
Step 1.
Open a Web browser on a computer that connects to the server and in the Address or URL field,
type the IP address or host name of the IMM to which you want to connect.
Note: If you are logging on to the IMM for the first time after installation, the IMM defaults to DHCP.
If a DHCP host is not available, the IMM assigns a static IP address of 192.168.70.125. The MAC
address tag provides the default hostname of the IMM and does not require you to start the server.
Step 2.
On the Login page, type the user name and password. If you are using the IMM for the first time,
you can obtain the user name and password from your system administrator. All login attempts are
documented in the event log.
Note: The IMM is set initially with a user name of USERID and password of PASSW0RD (passw0rd
with a zero, not a the letter O). You have read/write access. You must change the default password
the first time you log on.
Step 3.
On the Welcome page, type a timeout value (in minutes) in the field that is provided. The IMM
will log you off of the Web interface if your browser is inactive for the number of minutes that
you entered for the timeout value.
Step 4.
Click Continue to start the session. The System Health page provides a quick view of the system
status.
Enabling the Intel Gigabit Ethernet Utility program
Use this information to enable the Intel Gigabit Ethernet Utility program.
The Intel Gigabit Ethernet Utility program is part of the server firmware. You can use it to configure the
network as a startable device, and you can customize where the network startup option appears in the
startup sequence. Enable and disable the Intel Gigabit Ethernet Utility program from the Setup utility.
Configuring the Gigabit Ethernet controller
Use this information to configure the Ethernet controller.
.
Chapter 3
Configuration information and instructions
109
Advertisement
Table of Contents
Troubleshooting
