Step 4.
Tighten the thumbscrews on the rear of the cover to secure the cover to the chassis.
Step 5.
Install the server into the rack enclosure and tighten the two front thumbscrews to secure the
server in the rack.
Attention: Two or more people are required to install the system in a rack cabinet.
Updating the server configuration
Use this information to update the server configuration.
When you start the server for the first time after you add or remove a device, you might receive a message
that the configuration has changed. The Setup utility starts automatically so that you can save the new
configuration settings.
Some optional devices have device drivers that you must install. For information about installing device
drivers, see the documentation that comes with each device.
If the server has an optional RAID adapter and you have installed or removed a hard disk drive, see the
documentation that comes with the RAID adapter for information about reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see "Configuring the Gigabit
Ethernet controller" on page 109.
Cover
Thumbscrew
.
Chapter 2
Installing optional devices
93