Lenovo System x3630 M4 Installation And Service Manual page 317

Step 5. Reconnect the power cable and signal cables that you removed.
Note: You can refer to the internal cable routing section "Internal cable routing" on page 173 for
further details.
Step 6. Install the server top cover (see "Replacing the server top cover" on page 321).
Step 7. Reinstall the drives or filler panels.
Step 8. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices
and the server.
Removing the hot-swap backplane in the optional rear hard disk drive cage
Use this information to remove the hot-swap backplane in the optional rear hard disk drive cage.
To remove the hot-swap backplane in the optional rear hard disk drive cage, complete the following steps.
Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 36.
Step 2. Turn off the server (see "Turning off the server" on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3. Remove the server top cover (see "Removing the server top cover" on page 39).
Step 4. Remove all hot-swap hard disk drives in the optional rear hard disk drive cage (see "Removing a
hot-swap hard disk drive" on page 177).
Step 5. Lift the backplane out of the optional rear hard disk drive cage.
1
2
3
Locating Plate
.
Chapter 6 Removing and replacing components
303