Lenovo System x3630 M4 Installation And Service Manual page 279

Hide thumbs Also See for System x3630 M4:

Table of Contents

Install the air baffle (see "Replacing the air baffle" on page 323).

Install the PCI riser-card assembly (see "Replacing a PCI riser-card assembly" on page 237).

Install the server top cover (see "Replacing the server top cover" on page 321).

Step 10. Reconnect the power cord and any cables that you removed.

Step 11. Turn on the peripheral devices and the server.

Removing the front USB connector assembly cable

Note: The server configuration you have bought may either have the front USB connector assembly inside

the media cage or on the side of the server.

To remove the front USB connector assembly cable that is inside the media cage, complete the following

1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 36.

2. Turn off the server (see "Turning off the server" on page 26) and all attached peripheral devices.

Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.

3. Remove the server top cover (see "Removing the server top cover" on page 320).

4. Remove the PCI riser-card assembly (see "Replacing a PCI riser-card assembly" on page 237).

5. Remove the air baffle (see "Removing the air baffle" on page 322).

6. Disconnect the USB, video, CD/DVD and operator information panel cables from the system board.

Please remember the relevant cable routing.

Removing and replacing components

Troubleshooting