Removing And Replacing Tier 2 Crus - Lenovo System x3630 M4 Installation And Service Manual

Hide thumbs Also See for System x3630 M4:

Table of Contents

Align the backplane with the slot on the optional rear hard disk drive cage.

Lower the backplane into the optional rear hard disk drive cage. Make sure the three alignment

pins securely engages the three holes on the hard disk drive cage.

Install the hot-swap hard disk drives in the optional rear hard disk drive cage (see "Replacing a

hot-swap hard disk drive" on page 178).

Install the server top cover (see "Replacing the server top cover" on page 321).

Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices

and the server.

Removing and replacing Tier 2 CRUs

You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type

of warranty service that is designated for your server.

The illustrations in this document might differ slightly from your hardware.

Removing a microprocessor and heat sink

Use this information to remove a microprocessor and heat sink.

Alignment pins

Removing and replacing components