Table of Contents
Advertisement
3
1
Step 5.
Rotate the rear hard disk drive cage outwards
cage
3
out of the chassis.
Step 6.
If you are instructed to return the rear hard disk drive cage, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Replacing an optional hot-swap rear hard disk drive cage
Use this information to replace an optional hot-swap rear hard disk drive cage.
To install the optional rear hot-swap hard disk drive cage, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page vand "Installation guidelines" on
page 36.
Step 2.
Turn off the server (see "Turning off the server" on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3.
Remove the server top cover (see "Removing the server top cover" on page 320).
Step 4.
If a drive filler cage is installed in the chassis, loosen the screw that secures the drive filler cage
to the chassis; then, rotate the drive filler clockwise and remove the drive filler out of the bay
from the server. Go to step 8.
Note: If 2U PCI riser-card assemblies are installed in the server, go to step 5.
2
Release latch
1
2
. Then, carefully pull the rear hard disk drive
.
Chapter 6
Removing and replacing components
183
Advertisement
Table of Contents
Troubleshooting
