Lenovo System x3630 M4 Installation And Service Manual page 262

Hide thumbs Also See for System x3630 M4:

Table of Contents

4. Install the screws to secure the operator information panel to the side of the server.

5. Slide the cable arm cover into the retention slots and install the screws to secure it on the side of

the chassis.

Note: The cable is routed on the outside of the chassis and connected to the system board. The cable

must be protected by the cable cover on the side of the chassis.

6. Install the air baffle (see "Replacing the air baffle" on page 323).

7. Install the PCI riser-card assembly (see "Replacing a PCI riser-card assembly" on page 237).

8. If you have the optional hot-swap rear hard disk drive cage installed, rotate it down (see "Rotating the

optional hot-swap rear hard disk drive cage down" on page 181).

9. Install the server top cover (see "Replacing the server top cover" on page 321).

10. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices

and the server.

Removing the operator information panel

Use this information to remove the operator information panel.

Note: The server configuration you have bought may either have the operator information panel inside the

media cage or on the side of the server.

To remove the operator information panel that is inside the media cage, complete the following steps:

1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 36.

2. Turn off the server (see "Turning off the server" on page 26) and all attached peripheral devices.

Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.

3. Remove the server top cover (see "Removing the server top cover" on page 320).

4. Remove the PCI riser-card assembly (see "Removing a PCI riser-card assembly" on page 235).

5. Remove the air baffle (see "Removing the air baffle" on page 322).

6. Disconnect the USB, video, CD/DVD and operator information cables from the system board. Please

remember the relevant cable routing, as you will need to reconnect them to the system board when

installing the operator information panel.

Lenovo System x3630 M4 Installation and Service Guide

Operator information panel

Operator information

Troubleshooting