Installation; First Power-On - Technogym RECLINE EXCITE Service Maintenance Manual

5.3. INSTALLATION

To correctly install the machine, proceed as follows:
1. Ensure that the specifications and requirements for installation have been met (see paragraph
5.1. "Specifications and requirements").
2. Position the machine as specified above, on a level surface that is free of vibrations and has
sufficient carrying capacity for the combined weight of the machine and user.
3. The machine is shipped fully assembled and packed in a carton fixed to a wooden pallet.
Only for the 500, 700 and 700E models:
4. Connect the mains lead to the power inlet socket on the machine.
5. Place the on/off switch in the "0" position.
6. Plug the mains lead into the wall outlet.
Only for the 700E model:
7. Connect the antenna cable to the wall outlet.

5.4. FIRST POWER-ON

After completing the installation procedure, the machine is ready for use.
On the 500, 700 and 700E models, simply turn the on/off switch from position 0 to position 1, while
on the 500SP and 700SP models it is necessary to get on the machine and start pedaling.
On power-up the machine performs a self test of the upper and lower assemblies. At the end of this
the machine goes into standby, awaiting a keyboard command.
To check the correct operation of the machine:
• get on the machine;
• begin exercising;
• check that the displayed speed varies accordingly;
• check that the exercise resistance varies when the "+" and "-" keys are pressed, and that the
effort level LEDs turn on and off accordingly;
• put on the heart rate meter and check that the machine correctly reads the heart rate value;
• only on 700, 700SP and 700E grasp the sensors and check that the machine correctly reads the
heart rate value.
Page 5.2
RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3