Technogym RECLINE EXCITE Service Maintenance Manual page 90

Figure 7.1-11
Figure 7.1-12
Page 7.6
RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
5. Shift the rubber bushings b.
6. Back off the 2 grab screws c using a 6-mm
Allen wrench.
7. Back off the 2 screws d, using a 6-mm Allen
wrench.
8. Remove the handlebar.
9. Back off the 3 screws e, using a 6-mm Allen
wrench, to remove the rear display support.
To reassemble the display, carry out the above
steps in reverse order.
During reassembly, lock down the
screws c and d using a torque wrench set
for 22 Nm.