Technogym RECLINE EXCITE Service Maintenance Manual page 118

Only 700, 700E and 700SP models
Figure 7.17-2
Figure 7.17-3
Figure 7.17-4
Page 7.34
RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
1. Move the saddle into position 8.
2. Protect the equipment frame using a cloth as
shown in the figure.
3. On both side, disassemble the 2 pulleys on
which the saddle moves, backing off the nut
a using a 17-mm wrench and locking down
the eccentric pin b using a 24-mm wrench.
4. Turn the saddle over its back as shown in the
figure.
5. Pay attention that the saddle stays over the
cloth and that the hand sensor interface board
cable is not too tight.
7. Back off the two fixing screws c of the cable
holder, using a 2.5-mm Allen wrench.
During reassembly, lock down the
screws c using a torque wrench set for 3
Nm.
Continued on following page →