Installation Procedure - Technogym RECLINE EXCITE Service Maintenance Manual

RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
4.6.1. I
NSTALLATION PROCEDURE
WARNING: Do not perform this installation if the SW version of the brake interface
board is 9.56.x or lower.
NOTE: It is always advisable, in any case, to upgrade the brake interface board to the
latest SW version.
Figure 4.6-1
Figure 4.6-2
The upgrade kit consists of:
(1) Back of the display;
(2) Display support flange
(cod. 0C001412AA);
(3) Connector plate (cod. 0G000353AB);
(4) Upper handlebar cover
(cod. 0C000529AA);
(5) Lower handlebar cover
(cod. 0C000530AA);
(6) CB-18 cable (cod. 0WC000443AB);
(7) Code sticker (cod. 0E109);
(8) Union connector (cod. 0K00303AA);
(9) Self-tapping screws (cod. 0Z00090) and
washers (cod. 0Z343);
(10) Low cheese-head screw
(cod. 0ZV00011);
(11) Cheese-head screws (cod. 0Z165);
(12) Black screws (cod. 0ZV00140AA);
(13) Self-tapping screws (cod. 0Z775);
(14) 12-inch LCD display assembly.
Page 4.5