Technogym RECLINE EXCITE Service Maintenance Manual page 44

Figure 4.6-9
Figure 4.6-10
Figure 4.6-11
Page 4.8
RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
21. Insert cable 6 CB-18, routing it toward the
display alongside the group of cables which
connect the upper and lower parts of the
machine. More specifically:
• insert it into the left part of the 2 column
sections
• when inserting it into the second column
section, route it along the back as
indicated in the box.
22. Use a cable tie to attach cable 6 CB-18 to the
existing group of cables.
23. Reassemble the right guard that was
disassembled previously.
24. Move away the 2 rubber covers h to access
the screws k.
25. Back off the 2 screws k using a 6-mm hex T-
wrench.
26. Back off the 3 screws f using a 6-mm hex T-
wrench.
27. Remove the handlebar.
28. Back off the 3 screws g using a 6-mm hex T-
wrench.
29. Remove the display support.
30. Back off the 2 screws i using a 6-mm hex T-
wrench.
31. Remove the handlebar.
32. Back off the 3 screws j using a 6-mm hex T-
wrench.
33. Remove the display support.
34. Reassemble
disassembled previously.
Continued on following page →
the handlebar that was