Technogym RECLINE EXCITE Service Maintenance Manual page 61

RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
(1) Place the tester probes across the ends of the cable from the alternator. The measured voltage
should be approximately 15-17 VDC at a speed of about 30 RPM.
(2) As for step (1) but across pins 1 and 2 of connector CN3 on the brake board.
(3) Using a tester, check that all the output voltages on connector CN1 of the brake board are
correct, referring to paragraph 2.8. "Cables".
(4) As for step (3) but on connector CN7 of the display board.
(5) As for step (3) but on connector CN7 of the digital plan board.
(6) As for step (3) but on connector CN6 of the digital plan board.
(7) As for step (3) but on connector CN1 of the LED board.
Page 6.13