Disassembling The Platforms With Csafe Board Connectors And Power Entry Module - Technogym RECLINE EXCITE Service Maintenance Manual

RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
7.14. DISASSEMBLING THE PLATFORMS WITH CSAFE BOARD
CONNECTORS AND POWER ENTRY MODULE
Figure 7.14-1
Figure 7.14-2
The front and rear platforms house the following
components:
• connector of the cable leading to the CSafe
board (front platform, on the right in the
figure);
• Power entry module (500, 700 e 700E) or
battery charger socket (500SP e 700SP) (rear
platform, on the left in the figure).
1. To access the connectors, turn the machine
over on one side.
2. Back off the screws a of the platform which
houses the desired connector, using a
medium Phillips screwdriver.
At this point it is possible to:
3. Unplug connector b of the cable which goes
up to the CSafe board.
4. Back off the two screws c and remove the
Power entry module.
Continued on following page →
Page 7.29