Technogym RECLINE EXCITE Service Maintenance Manual page 94

Figure 7.2-8
Figure 7.2-9
Figure 7.2-10
Page 7.10
RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
Connectors board b:
1. Unplug the antenna cable f going to the
splitter.
2. Back off the 4 screws g using a small Phillips
screw driver.
3. Remove the board from the display, taking
care not to damage the connector that
connect it to the CPU board.
CPU board c
1. Unplug the cables indicated in the figure,
coming from TTL board, LCD inverter,
keyboard, headphone jack and external
speakers.
2. Disconnect the cable coming from the TTL
board:
• Push open the clip fasteners of the
connector on the CPU board as shown in
the highlight;
• pull the cable out.
3. Back off the 5 screws h using a small
Phillips screwdriver.
4. Remove the CPU board.
Speakers d:
1. Unplug the cables indicated in the figure
from the CPU board.
2. Back off the 4 screws of each speaker, using
a small Phillips screwdriver.
3. Remove the speakers.
Continued on following page →