Special Maintenance Operations; Setting Up The Operation; Checking The Working Conditions; Performing The Routine Maintenance Procedure - Technogym Top 600 XTPRO Service Maintenance Manual

TOP 600 XTPRO: Service & Maintenance Manual - rev. 2.0

10.3. SPECIAL MAINTENANCE OPERATIONS

These operations can only be carried out by a qualified technician specifically trained by
Technogym and authorized to carry out machine installation and adjustments, as well as
special maintenance operations or repairs which require special knowledge of the
machine, its operation, safety systems and working procedures.
The special maintenance procedures involve checking the operation, lubrication, wear and tension
of the mechanical components so as to ensure perfect and safe operation of the machine. It is
recommended to carry out these operations at least once every 6 months.
For the special maintenance of the machine, proceed as follows:
10.3.1. S
ETTING UP THE OPERATION
1. Turn off the machine by placing the switch in the 0 position (OFF).
2. Unplug the mains lead from the wall outlet
3. Open the machine guards
10.3.2. C
HECKING THE WORKING CONDITIONS
1. Check that the machine is connected directly to the wall outlet, without any extension cords,
and that the outlet is correctly earthed.
2. If the machine is supplied in cascade through other machines, check that no more than 5
machines (maximum number permitted) have been connected together in this way.
3. Using a multimeter, check that the machine earth node is correctly connected to earth.
10.3.3. P
ERFORMING THE ROUTINE MAINTENANCE PROCEDURE
1. Carry out the procedures described in paragraph 10.2. " Routine maintenance operations".
10.3.4. C
HECKING THE WIRING AND CONNECTIONS
1. Check the condition of all the cables:
• External conditions;
• Possible rusting of the connectors;
• Electrical continuity of the individual conductors;
• Isolation of individual conductors relative to ground.
Repair and/or replace any non-conforming cables.
2. Check the condition of the fuses using a tester.
10.3.5. C
HECKING THE DISPLAY
1. Check the operation of all the keys on the keyboard.
2. Check the operation of all the LEDs and the buzzer on the display.
Page 10.3