Pass
IPsec Pass-through
Through
PPTP Pass-through
L2TP Pass-through
Quality of Service (QoS)
VPN
IPsec
VPN Simple Settings
Router Command
WAN Port Mirroring
Conditions
•
This PBX supports only IPv4. It does not support IPv6. However, the IPv6 Bridge feature is supported.
For details, refer to 8.6.6 Protocol Bridge—IPv6 Bridge.
•
KX-NSN101 (Built-in Router) is required to use all the features in this section. This activation key is required
at each site where the built-in router will be used.
8.6.2 WAN Connection
Description
The following protocols are supported for setting the IP address of the WAN interface.
Protocol
IPoE
PPPoE
Feature
Sets a static IP address or retrieves an IP address dynamically
from a DHCP server using the DHCP client feature.
Obtains an IP address dynamically from a PPPoE server.
Description & Reference
Allows IPsec protocol packets to/from a
specified device on the LAN to pass across the
WAN–LAN boundary.
® 8.6.19 IPsec Pass-through
Allows PPTP protocol packets to/from a
specified device on the LAN to pass across the
WAN–LAN boundary.
® 8.6.20 PPTP Pass-through
Allows L2TP protocol packets to/from a
specified device on the LAN to pass across the
WAN–LAN boundary.
® 8.6.21 L2TP Pass-through
Quality of Service settings offered by the
built-in router.
® 8.6.22 Quality of Service (QoS)
VPN connection over IPsec.
® 8.6.23 VPN—IPsec
Provides simple VPN connectivity.
® 5.4.1 Easy Setup Wizard
® 8.6.24 VPN—VPSS Setting
Displays the built-in router's status.
® 8.6.25 Router Command
Mirrors traffic from the WAN interface onto the
MNT port.
® 8.6.26 WAN Port Mirroring
Description
8.6.2 WAN Connection
Installation Manual
379