Panasonic KX-NS1000 Installation Manual page 301

Installing IP-CSs (KX-NS0154 only) at a remote site with Built-in Media Relay
Gateway
You can install IP-CSs (KX-NS0154 only) at the remote site directly or from the local site as follows.
1.
Register the IP-CS. For details, refer to corresponding manuals of KX-NS0154.
2.
Programme the settings for the IP-CS.
a. Click Setup ® PBX Configuration ® Configuration ® Slot.
b. Click Virtual ® V-IPCS4.
c.
Move the mouse pointer over the V-IPCS4 card (Virtual 4 IP Cell Station Interface Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property.
e.
Click the Remote Place tab.
f.
Configure the items shown below.
•
Change the value to Remote (MRG) for Phone Location.
g.
Click OK.
3.
Unplug the AC adaptor of the IP-CS, and then plug it in again to reboot the IP-CS manually. The IP-CS
will download settings automatically.
Installing KX-UT series SIP phones at a remote site with Built-in Media Relay
Gateway
There are 2 methods to install KX-UT series SIP phones at a remote site:
•
Set up the phones at the main site using the KX-NS1000, and then send them to the remote site.
•
Set up the phones without connecting them to the KX-NS1000 at the main site, and then send them to the
remote site.
Setting up KX-UT series SIP phones at the main site, and then sending them to remote site
1.
Register the phone. For details, refer to "5.9.1 Registering IP Telephones".
2.
Programme the settings for the phone.
a. Click Setup ® PBX Configuration ® Configuration ® Slot.
b. Click Virtual ® V-UTEXT32.
c.
Move the mouse pointer over the V-UTEXT32 card (Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property.
e.
Click the Remote Place tab.
f.
Configure the items shown below.
•
Change the value to Remote (MRG) for Phone Location.
•
Select a protocol (HTTP/HTTPS) for Protocol for Remote SIP-MLT.
Note
When a SIP phone at a remote site uses the internet to communicate with a KX-NS1000, use
the HTTPS protocol for security. If the connection is on a VPN and is protected, you may use
the HTTP protocol.
g.
Click OK.
3.
Unplug the AC adaptor of the phone, and then plug it in again to reboot the phone manually. The phone
will download settings automatically.
Note
•
After downloading the setting information for the remote site, the KX-UT series SIP phone will not
connect to the KX-NS1000 if it is connected to the LAN at the main site. After some time, the
KX-UT series SIP phone will display "9002: Connection Failed".
5.9.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway
Installation Manual 301