To register the IP-PT or KX-UT series SIP phone using the wizard:
If the Connection column for the port is INS, click INS,
and then click OUS on the dialogue box to change the
Enter the MAC address of the IP-PT or SIP phone in the
IP Phone Registration ID (MAC Address) cell.
Once the IP-PT or SIP phone is successfully registered,
its status will update to show "Registered".
In the Connection column for the port, click OUS, and
then click INS on the dialogue box to change the port's
For KX-UT series SIP phones only:
Follow the procedure below to change the IP Terminal
Registration Mode from Manual to Full Automatic.
Click Setup ® PBX Configuration ®
Configuration ® Slot ® Site Property ® Main.
In the Main tab, select Full Automatic for IP
Terminal Registration Mode.
A dialogue box will appear. Non-registered (available)
extension numbers and names are displayed on the left.
Highlight numbers and names and click the right
arrow to select them for registration, and then click
Click Next. A screen will appear with information on
the current IP-PT or SIP phone extension number
and name, and index number for programming.
If the IP-PT or SIP phone has been
connected to the LAN and power has been
turned on, the IP address of the PBX will be
If not, connect the IP-PT or SIP phone to the
LAN and turn the power on within 15 minutes
after this operation is done. The IP address
of the PBX will then be assigned
If the registration is still in progress, the dialogue box
will show "Registration Executing".
If the registration is successful, the dialogue box will
show "Registration Completed". Click Close.
Once the IP-PT or SIP phone is successfully
registered, its status will update to show
5.9.1 Registering IP Telephones