Panasonic KX-NS1000 Installation Manual page 140

4.2.11 Wall Mounting
Wall Mounting Procedures
1.
Measure the actual space as indicated below to mark the 4 screw positions on the wall. Install 4 anchor
plugs in the wall and drive in 4 screws (A) leaving a gap of 5 mm between the screw head and the wall.
Screw (A)
Note
•
As indicated above, do not tighten the screws fully. You will tighten the screws in step 6.
•
The pull-out strength of the installation area must be at least 294 N (30 kgf) per screw.
2.
Fix the Top Bracket to the left side of the PBX with 3 screws (B). (Recommended torque: 0.8 N·m
[8.2 kgf·cm] to 1.0 N·m [10.2 kgf·cm])
Screw (B)
3.
Fix the Bottom Bracket to the right side of the PBX with 3 screws (B). (Recommended torque: 0.8 N·m
[8.2 kgf·cm] to 1.0 N·m [10.2 kgf·cm])
140 Installation Manual
87 mm
463 mm
192 mm
Screw (B)
Installation procedure for concrete walls.
Hammer Anchor Plug
Screw (A)
Screw (A)
Drive the
screw 5 mm
to this point.
8 mm
30 mm