5.8.1 Assigning IP Addressing Information
Not using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-PT is on
the same LAN as the PBX
Only the PBX's IP address can be assigned automatically to the IP-PT in the process of being registered
to the PBX. For details about registering the IP-PT, refer to "5.9.1 Registering IP Telephones".
Follow the procedure below to assign the IP address of the IP-PT, the subnet mask address, and the default
gateway address manually.
If you need to set VLAN parameters, follow the procedure described in "5.8.2 Setting VLAN
Parameters" after assigning the IP addresses, without ending programming.
KX-NT300 series (except KX-NT321) and KX-NT500 series (except KX-NT551)
To start programming
Supply power to the IP-PT.
To set the IP address of the IP-PT
To set the subnet mask address
Select "Subnet Mask".
To set the default gateway address (if required)
Select "Default Gateway".
To enter the IP address of the Secondary PBX
(optional for KX-NT300 series [Software version 2.00 or later only] and
KX-NT500 series [Software version 1.00 or later only])
Return to the
Continued on next page
Press "SETUP" when it is displayed.
for DHCP setting.
Subnet Mask Address*
PBX IP Address
Select "IP Address".
Default Gateway Address*
Select "PBX IP