5.9.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway
5.9.4 Installing IP Phones at a Remote Site with a Built-in Media
The KX-NS1000 contains a built-in Media Relay Gateway.
You can install and register IP-PTs (KX-NT500 series), Panasonic IP-Softphones, IP-CSs (KX-NS0154 only),
KX-UT series SIP phones and third party SIP phones at a remote site without adding an SBC (Session Border
Controller). Also, you do not need to configure special network settings (NAT traversal, etc.) at the remote site.
This feature does not require an activation key.
There is no limit to the number of terminals that can use the Media Relay Gateway feature.
However, there are some conditions, as follows:
Peer-to-peer communication is not supported for the built-in Media Relay Gateway.
The number of terminals using TR-069 (CWMP)-based HTTPS is limited.
For information about which telephone models support the built-in Media Relay Gateway, consult your
Programming the KX-NS1000 with Built-in Media Relay Gateway
Follow the procedures below to configure remote port settings using Web Maintenance Console.
For the procedures below, programme WAN side IP information of the router at the main site. This
information is sent to KX-NT500 series, IP-CSs (KX-NS0154 only), or KX-UT series SIP phones in the
remote site after completing all programming.
For Site Property Settings
Click Setup ® PBX Configuration ® Configuration ® Slot.
Move the mouse pointer over Site Property.
A menu will be shown under the mouse pointer.
Click the Media Relay tab.
Built in Media