Setting up KX-UT series SIP phones without connecting to the KX-NS1000 at the main site,
and then sending them to the remote site
Log in to the Web Maintenance Console of the site where the SIP phones will be registered.
For details about logging in to a Slave unit via the Master unit, refer to "3.1 Home Screen" in the PC
Click Utility ® File ® File Transfer PBX to PC.
Select the config file according to the protocol used and then download it to your PC.
HTTP is used
HTTPS is used
For more details about downloading files from a PBX to a PC, refer to "7.2.2 Utility—File—File Transfer
PBX to PC" in the PC Programming Manual.
xx: Site ID (2 digits)
yyyy: Site name
Spaces as well as the following characters in site names will be replaced with underscores.
/, :, *, ?, ", <, >, | (vertical bar), &, +
In some cases, the full site name may not be included in the file name even if it is less than 32 characters.
Download the config file to the KX-UT series SIP phone via the Web user interface of the KX-UT series
For details, refer to "When the SIP Phones are in a different LAN (Remote site installation)" in
"5.8.1 Assigning IP Addressing Information".
Connect the KX-UT series SIP phone to the LAN at the remote site.
Register the KX-UT series SIP phone to the KX-NS1000 as a remote extension.
Click Setup ® PBX Configuration ® Configuration ® Slot.
Click Virtual ® V-UTEXT32.
Move the mouse pointer over the V-UTEXT32 card (Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
Click Port Property.
Click Remote Place tab.
Configure the items shown below.
Change the value to Remote (SBC) for Phone Location.
Change the value to Enable for Web-MC Ability.
Select a protocol (HTTP/HTTPS) for Protocol for Remote SIP-MLT.
Select the same value as you selected for NAT - SIP Proxy Server Port No. in step 5 of
"Programming the KX-NS1000" in this section.
Register the KX-UT series SIP phone. For details, refer to "5.9.1 Registering IP Telephones".
You can select HTTPS for Protocol for Remote SIP-MLT only when Phone Location is set as
If the KX-UT series SIP phones don't work normally, confirm if the KX-UT series SIP phones are able
to access to internet.
(Up to 32 characters
5.9.3 Installing SIP Phones at a Remote Site