Panasonic KX-NS1000 Installation Manual page 181

Connection
Use 4-pin and 2-pin terminal blocks (included with the card) for connection.
1.
While pressing on the orange tab at the bottom of the terminal block using a screwdriver, insert the wire
into the upper hole as shown below. Repeat this procedure for each doorphone, door opener, and/or
external sensor wire to connect.
Refer to "4.7.1 DOORPHONE Card (KX-NS0161)" for pin assignments.
For information about wiring, refer to "Connecting to the DOORPHONE Card".
Doorphone
Door Opener
External Sensor
4.9 Connecting to a Doorphone, Door Opener, and/or External Sensor
Installation Manual 181