Programming The Address Translation Table - Panasonic KX-NS1000 Installation Manual

5.6.2 Programming the Address Translation Table

Note
For more details about hunt pattern assignment, refer to "9.12.2 PBX Configuration—[1-1]
Configuration—Slot—Shelf Property - Virtual IP Gateway—Hunt Pattern" in the PC Programming Manual.
5.6.2 Programming the Address Translation Table
The function of an address translation table in a VoIP network is to provide 2-way translation of telephone
numbers and IP addresses
knowing the destination IP address.
The procedure below demonstrates the process of programming the address translation table at the local PBX.
After the address translation table at the local PBX has been fully programmed, repeat the procedure for the
address translation table at the remote PBX with the appropriate setting values.
IP address-to-telephone number translation can also be handled by using an H.323 Gatekeeper device. To configure Gatekeeper
*1
devices, refer to the manufacturer's documentation. This manual focuses on the method using the V-IPGW16 card's internal address
translation capabilities.
232 Installation Manual
. Therefore, a caller can reach the destination by dialling the number without
*1
1.
2.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b.
Click System Property.
c.
Click the V-IPGW tab.
d.
Click GW Settings.
In the Main tab, do the following to configure the
gateway entry for the remote PBX:
a.
In the GW Name cell, type a unique identifier of the
destination in the VoIP network.
b.
In the GW IP Address cell, type the IP address of
the destination gateway device.
c.
In the GW Group cell, select None.
Note
Having the value None for GW Group means
that the destination gateway device does not
belong to any gateway group. Grouping is useful
when installing multiple gateway devices at one
location. For details, refer to "9.4 PBX
Configuration—[1-1]
Configuration—Slot—System Property—
Group" in the PC Programming Manual.
d.
Click OK to return to the System Property screen.
GW