Master data converter
System data from a KX-TDE series, KX-NCP series or KX-TDA100D PBX can be converted for use with the
KX-NS1000 to ensure a seamless transition to the new system.
Connect a PC to a KX-TDE series, KX-NCP series or KX-TDA100D PBX and then start the Unified
For details about connecting a PC to a PBX or for details about the Unified Maintenance Console, refer to
the appropriate documentation.
In the Unified Maintenance Console, save the PBX's system data file (DxSYS
For details about saving the system data file to the PC, refer to the appropriate documentation.
Start Web Maintenance Console for the KX-NS1000 in Off-line mode.
In the Programme Launcher, click Database Converter.
In Select Converter Type, click Master data converter.
Select the appropriate option according to whether a legacy gateway is connected.
In Select Original File Name, select the system file (DxSYS) you saved in step 2 as the file to convert.
An image of converting the file to the KX-NS1000 is displayed on the screen.
Click "Next". The Easy Setup Wizard starts as it would for a normal setup of the KX-NS1000.
Specify the following Master site parameters as necessary:
SNTP / Daylight Saving
This tool displays a "stacking style" image on the screen as necessary (e.g. when converting
KX-TDE600/KX-TDE620 data to KX-NS1000 data).
The system data will be converted and a system data file for the KX-NS1000 (DCSYS) is created. It will
complete within one minute.
After conversion is complete, you can click Save on the Result of Converting screen and save the results
file (ConvertReport.txt) to your PC.
On the Save Convert File of System Data screen, save the created DCSYS file.
Select Finish of Database Conversion, and then click OK.
Conversion is complete.
Start Web Maintenance Console, and click Open -Offline Mode in the Programme Launcher.
Select the created DCSYS file, and configure any additional required parameters.
For details about the parameters, refer to the PC Programming Manual.
Start the KX-NS1000, and then transfer the system data file (DCSYS) to the PBX.
For details about transferring the file, refer to "1.2.2 PC Programming Using Off-line Mode—Uploading
Programmed Settings to the PBX" in the PC Programming Manual.
"DxSYS" refers to the following:
The software version for KX-TDE series, KX-NCP series or KX-TDA100D PBXs must meet the latest version requirements shown
in the Data Converter tool. If the requirements are not met, you must use the Unified Maintenance Console to upgrade the version
to the one shown in the table below, and then save the DxSYS file.
Activation keys are not brought over during data conversion. You must supply the necessary activation
keys for the KX-NS1000 separately.
The following numbering plan settings are brought over during data conversion:
5.3 Starting Web Maintenance Console
) to the PC.