Panasonic KX-NS1000 Installation Manual page 297

8.
Move the mouse pointer over Site Property.
A menu will be shown under the mouse pointer.
9.
Click Main.
10.
Click the Port number tab.
11.
Programme the following items according to the protocol used by KX-UT series SIP phones in the remote
site.
a.
When the KX-UT series SIP phones are using HTTPS:
•
CWMP (HTTPS) Port No. for SIP-MLT
•
Data Transmission Protocol (HTTPS) Port No. for SIP-MLT
b.
When the KX-UT series SIP phones are using HTTP:
•
CWMP (HTTP) Port No. for SIP-MLT
•
Data Transmission Protocol (HTTP) Port No. for SIP-MLT
Note
For the default port numbers of the KX-NS1000, refer to "8.5 Port Security".
12.
Click OK.
Using a KX-NS1000 as an NTP server
When the KX-NS1000 will be used as a NTP server, follow the procedures below.
1. Click Setup ® Network Service ® Server Feature ® NTP.
2.
Select Enable.
3.
Click OK.
Programming the router at the main site with Built-in Media Relay Gateway
Port forwarding settings (Router – KX-NS1000)
Configure the following items for port forwarding between the Media Relay Gateway and the router.
For the KX-NT500 series:
Application
PTAP
MGCP
5.9.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway
LAN Side Port Number
Signalling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.14 PBX Configuration—[1-1]
Configuration—Slot—V-IPEXT32
—Card Property")
Signalling (MGCP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.14 PBX Configuration—[1-1]
Configuration—Slot—V-IPEXT32
—Card Property")
WAN Side Port Number
Signalling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.14 PBX Configuration—[1-1]
Configuration—Slot—V-IPEXT32
—Card Property")
NAT - MGCP Server Port No.
(Use the same value as in step 5 of
"Programming the KX-NS1000 with
Built-in Media Relay Gateway".)
Installation Manual 297