Starting The Kx-Ns1000 - Panasonic KX-NS1000 Installation Manual

4.13 Starting the KX-NS1000

WARNING
Make sure that the AC outlet is properly earthed, then securely connect the 3-pin AC plug including
the earthed pin.
CAUTION
•
Use only the AC power cord included with the PBX.
•
Before touching the product (PBX, cards, etc.), discharge static electricity by touching ground or
wearing an earthing strap. Failure to do so may cause the PBX to malfunction due to static electricity.
•
Once you have started the PBX, if you unplug the PBX, do not initialise it again as described in "System
Initialisation Procedure". Otherwise, your programmed data will be cleared. To restart the PBX, refer
to "7.1.5 Restarting the KX-NS1000".
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
Installing the Hook Clip for the AC Power Cord
1.
Insert the hook clip into the hook clip hole.
Note
Use only the hook clip included with the PBX.
4.13 Starting the KX-NS1000
Installation Manual 193