Panasonic KX-NS1000 Installation Manual page 317

b.
Add slave sites using the Add Site Wizard, and then start One-look networking.
For more information about the Add Site Wizard, refer to "5.5 Programming a One-look Network".
When the KX-NS1000 is going to be a Slave unit.
a.
Add the site containing the KX-NS1000 as a Slave unit to the One-look network using the Add Site
Wizard, and then start One-look networking.
For more information about the Add Site Wizard, refer to "5.5 Programming a One-look Network".
Note
If desired, at this time import any data that was exported from the PBXs before beginning this stacking
procedure. The data should be imported to the Master unit.
For more information about importing data with Web Maintenance Console, refer to
"6.6 Tool—Import" in the PC Programming Manual.
Note
•
When starting PBXs after stacking with the KX-NS1000, start the KX-NS1000 before the stacked PBX.
•
When exchanging a PBX that is stacked with the KX-NS1000 and running already to a different model
of PBX, delete current legacy gateway settings using Web Maintenance Console before the exchange.
•
The activation keys that were obtained when the PBX was running are not available when the PBX is
stacked with a KX-NS1000.
•
Legacy gateways cannot be accessed by the PC Maintenance Console.
•
Legacy gateways support VPSs. For more details, refer to the documentation for the PBX.
Pre-installing stacked PBXs connected to the STACK-M card
Once a STACK-M card has been added to the physical shelf on the Slot screen, you can pre-install stacked
PBXs connected to the STACK-M card.
1.
Log in to Web Maintenance Console. For details, refer to "Connecting to Web Maintenance Console" in
"5.3 Starting Web Maintenance Console".
2. Click Setup ® PBX Configuration ® Configuration ® Slot.
3.
Place the mouse cursor over the STACK-M card, and in the menu that appears, click Pre-Install.
4.
In Cabinet Type, select the model of the PBX connected to connection port 1 of the STACK-M card, and
then click the arrow button.
5.
If a second stackable PBX is connected to connection port 2 of the STACK-M card, select the model of the
PBX connected to connection port 1, and then click the arrow button.
6.
Click OK when finished to complete pre-installation.
Programming Legacy Gateways
To programme legacy gateways that are stacked with a KX-NS1000, use Web Maintenance Console.
To log in to Web Maintenance Console, refer to "Connecting to Web Maintenance Console" in "5.3 Starting
Web Maintenance Console".
For more information about programming legacy gateways, refer to the PC Programming Manual.
6.2 Methods of Stacking PBXs
Installation Manual 317