Alpha 6000S series User Manual page 40

Setting of function code parameters: (example of changing Jog acceleration time, function code P2.01 from 6.0s to
3.2s)
Display
0.00
of LED
P R G
Operation
E S C
of key
monitoring go into
programming
state
state.display
parameter
group menu
P R G
E S C
Exit from
the
programming
state
In three-level menu state, no flicker bit for a parameter indicates that the function code cannot be modified, and the
possible reasons include:
 Modifying the value is forbidden because the parameter is actual measure value, or running record value or
fixed value. The function parameter cannot be changed when the inverter is at running state. However, it can
be changed at stop state.
 So stop the inverter and then change the parameter value.
 The inverter parameters are protected. If function parameter value PF.01=1 or 2, the parameters are forbidden
to be changed. This parameter protection function is to avoid operation mistake. To change the protection
parameters, change value of function code PF.01 to zero, then all the parameters can be changed
Note: When the digital encoder is damaged,

UP/DN activation method: UP/DN function can be activated by pressing the key combination
for 5s (operation illustration is shown in Fig3.8), which will reset after powering off. Parameter
JOG
PD.12 can be set by activating UP/DN function, please see PD.12 function description for details
 In monitoring or alarm mode: function of

In programming mode:
activated by pressing
run command control mode setting P0.07 = 0: keypad control into 4: serial communication)
39
-P 0- -P 2-
+ E N T E R
E NT E R
Enter
turn right 2
into
times,chose
parameter
parameter
code
group P 2
number
menu
-P 2-
P R G
E S C
Exit to
parameter
group
menu
Figure 3-7 Flow chart of parameter setting
JOG
JOG
acts as UP,
JOG
key or for 2s (operation illustration is shown in Fig. 3-9: modify the
JOG
P 2.00
P 2.01
+
turn right 1
Enter into
time,chose
parameter
parameter
value menu
code
numberP 2.01
003.2
P 2.02
E N T E R
save the
changed value
and exit to
parameter
code number
menu
key can set as UP,
and maintain unchanged
acts as DN. continuous augmentation function is
Chapter 3 Operation
006.0 003.0
-
E N T E R
Turn left 3
times to
chang the
number to 3
003.0
＞ ＞
+
Shift to
Turn right 2
times to change the
blinking
change the
place to
number to 2
right
key can be set as DOWN.
+
＞＞