Operation Method Of Keypad - Alpha 6000S series User Manual

Chapter 3 Operation
operation can be carried out by pressing
Shutdown state
parameter display or
operation state
parameter display or
fault alarm display

3.1.5 Operation method of keypad

Here are some examples of how to run the inverter by the keypad:
Monitoring object switching:
Display
50.00
of LED
Operation
＞＞
of key
Actual output
frequency
Fig. 3-5 Examples of running parameters display operations of (stopping switching method is the same as above)
Frequency adjustment at common running: (Example: change the setting frequency from 50.00 Hz to 40.00 Hz)
Display
0.00
of LED
Operation
of key
output
Turn left the
frequency
frequency setting
will blink.And
the monitoring
object is setting
This method applies to given frequency parameter adjustment when the initial display state is any state.
When the monitor display is set speed, analog PID digital setting, the parameters can be modified directly and can
display the set speed and analog PID digital setting by pressing
(levogyration).
38
ENTER
First-level
menu
Figure 3-4 Display menus of programming state
50.00 45.0
＞＞
Output frequency Output
before compensation current
50.00
-
-
turn left 1
time,seting
digital
frequency
encoder,the
decrease
keyboard will
automatically 0.01Hz
come into
state.Unit Hz
frequency
Figure 3-6 Flow chart of frequency setting
key, and it can exit by pressing
Second-level
menu
Editing mode
50.00
1440
＞＞
＞＞
Motor
Setting
rotate speed
frequency
49.99 49.50
-
Keep on
turnning,
the decrease
step length can
reach to
0.10Hz,seting
frequence can
decrease 0.10Hz
1 time.
PRG
key.
ESC
Third-level
menu
0.000
1440
＞＞ ＞＞
Seting
speed
40.00
-
The maximal Stop
step length trunning
can reach
keyboard will
to
automatically
1Hz.Depress
return to the
the Enter
key to save
the desired
value.
key (dextrorotation) or
+
＞＞
Actual
length
0.00
3 seconds
later,the
original
monitoring
object.
key
-