Alpha 6000S series User Manual page 121

Chapter 5 Detailed Function Introductions
P3.16 Terminal UP/DN rate
P3.17 UP/DN reference amplitude
Notes:
 Terminal UP/DN rate is used to define the change rate of reference frequency that is changed by terminal
UP/DN. UP/DN reference amplitude used to define that the span of reference frequency is changed by
terminal UP/DN.
3.18 Digital frequency UP/DOWN save selection
0: Receive STOP, UP/DN reference is reset to zero;
1: Receive STOP, UP/DN reference is not reset to zero, and not saved when power loss;
2: UP / DOWN set point not is reset to 0 after receiving STOP, which will save to function code after power off;
when P0.03 is set to 1, P0.02 adjusts power-off saving online.
Notes:
 UP / DOWN operation is shown in Fig. 5-3-3,5-3-4.
 When P0.03 is set to 1 during the keypad setting frequency: When P3.18 is set to 2, the digital set frequency
(P0.02) adjusts the power-off saving; when P3.18 is not set to 2, it will not be saved after power failure,
please see P0. 02 description for details.
P3.19 D0 terminal function definitions
P3.20 Y1 terminal function definition (reserve for 3004GB and
below models)
P3.21 Y2 terminal function definition (reserve for 3004GB and
below models)
P3.22 Y3 terminal function definition (reserve for 3004GB and
below models)
P3.23 Y4 terminal function definition (reserve)
P3.24 relay 1 (TA / TB / TC) output function selection
P3.25 relay 2 (BRA / BRB / BRC) output function selection
(reserve for 3004GB and below models)
120
FWD
Fig. 1
图 1
REV
COM
SB2
SB1
FWD
SB3
REV
Fig. 3
图 3
HLD
COM
RUN
F/R
COM
SB2
SB1
RUN
HLD
Fig. 4
K 图 4
F/R
COM
Setting range: 0.01~99.99Hz/s [1.00Hz/s]
Setting range:0.00~Frequency upper limit [10.00Hz]
Setting range: 0~2 [2]
Setting range: 0 ~ thirty-five [ 0]
Setting range: 0 ~ thirty-five [ 1]
Setting range: 0 ~ thirty-five [ 0]
Setting range: 0 ~ thirty-five [ 0]
Setting range: 0 ~ thirty-five [ 0]
Setting range: 0 ~ thirty-five [ nineteen]
Setting range: 0 ~ thirty-five [ 0]
Fig. 2
图 2