Table 22: Auto Provision Settings; Figure 61: Auto Provision Settings - Grandstream Networks UCM6510 User Manual

Enable Zero Config
Enable Automatic
Configuration Assignment
Automatically Assign Extension
Zero Config Extension
Segment
Firmware Version 1.0.10.39

Figure 61: Auto Provision Settings

Table 22: Auto Provision Settings

Enable or disable the Zero Config feature on the PBX. The default setting
is enabled.
By default, this is disabled. If disabled, when SIP device boots up, the
UCM6510 will only send the configuration path to the device when you
have any manual configuration on the device. This manual configuration
includes:
- Any configuration under BASIC and CUSTOM page of the device
in Zero Config page
- If any global or model template (expect for the default template) is
selected for the assigned device in Zero Config page.
Note:
When disabled, SIP devices can still be provisioned by manually sending
NOTIFY from the UCM6510 which will include the XML config file URL for
the SIP device to download.
If enabled, when the device is discovered, the PBX will automatically
assign an extension within the range defined in "Zero Config Extension
Segment" to the device. The default setting is disabled.
Click on the link "Zero Config Extension Segment" to specify the extension
range to be assigned if "Automatically Assign Extension" is enabled. The
default range is 5000-6299. Zero Config Extension Segment range can be
UCM6510 IP PBX User Manual Page 92 of 339