Table 31: Sip Extension Configuration Parameters - Basic Settings - Grandstream Networks UCM6510 User Manual

General
Extension
CallerID Number
Permission
SIP/IAX Password
Support Hot-Desking Mode
Auth ID
Enable Voicemail
Voicemail Password
Skip Voicemail Password
Verification
Disable This Extension
User Settings
First Name
Last Name
Firmware Version 1.0.10.39
Table 31: SIP Extension Configuration Parameters – Basic Settings
The extension number associated with the user.
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls using this rule.
Configure the password for the user. A random secure password will be
automatically generated. It is recommended to use this password for
security purpose.
If enabled, SIP Password will accept only alphabet characters and digits;
AuthID will be changed to the same as Extension.
Configure the authentication ID for the user. If not configured, the
extension number will be used for authentication.
Enable voicemail for the user. The default setting is "Yes".
Configure voicemail password (digits only) for the user to access the
voicemail box. A random numeric password is automatically generated. It
is recommended to use the random generated password for security
purpose.
When user dials voicemail code, the password verification IVR is skipped.
If enabled, this would allow one-button voicemail access. By default this
option is disabled.
If selected, this extension will be disabled on the UCM6510.
Note:
The disabled extension still exists on the PBX but can't be used on the
end device.
Configure the first name of the user. The first name can contain
characters, letters, digits and _.
Configure the last name of the user. The last name can contain
characters, letters, digits and _.
UCM6510 IP PBX User Manual Page 120 of 339