Fax Intelligent Route; Figure 108: Inbound Route - Multiple Mode - Grandstream Networks UCM6510 User Manual

Figure 108: Inbound Route - Multiple Mode

When Multiple Mode is enabled for the inbound route, the user can configure a "Default Destination" and a
"Mode 1" destination for this route. By default, the call coming into this inbound route will be routed to the default
destination.
SIP end devices that have registered on the UCM6510 can dial feature code *62 to switch to inbound route
"Mode 1" and dial feature code *61 to switch back to "Default Destination". Switching between different mode
can be easily done without web UI login.
For example, the customer service hotline destination has to be set to a different IVR after 7PM. The user can
dial *62 to switch to "Mode 1" with that IVR set as the destination before off work.

FAX INTELLIGENT ROUTE

The UCM6510 can automatically detect Fax and phone signal coming from the FXO port, and then forward Fax
or phone signal to the right destination. For example, when a regular phone call is coming, the UCM65100 will
be able to detect the phone signal and forward it through the correct inbound route to the destination; if Fax
Firmware Version 1.0.10.39 UCM6510 IP PBX User Manual Page 196 of 339