4. Click on "Detect" to start PSTN detection.
If there are two FXO ports connected to PSTN lines, use the following settings for auto-detection.
Detect Model: Auto Detect.
Source Channel: The source channel to be detected.
Destination Channel: The channel to help detecting. For example, the second FXO port.
Destination Number: The number to be dialed for detecting. This number must be the actual
PSTN number for the FXO port used as the destination channel.
If there is only one FXO port connected to PSTN line, use the following settings for auto-detection.
Firmware Version 1.0.10.39
Figure 91: UCM6510 PSTN Detection
Figure 92: UCM6510 PSTN Detection: Auto Detect
UCM6510 IP PBX User Manual
Page 151 of 339