Create New Iax Extension; Table 34: Sip Extension Configuration Parameters - Specific Time; Table 35: Iax Extension Configuration Parameters - Basic Settings - Grandstream Networks UCM6510 User Manual

Support Hot-Desking Mode
Enable LDAP
Enable WebRTC Support
Music On Hold
Call Duration Limit
Specific Time
Time Condition

CREATE NEW IAX EXTENSION

The UCM6510 supports Inter-Asterisk eXchange (IAX) protocol. IAX is used for transporting VoIP
telephony sessions between servers and terminal devices. IAX is similar to SIP but also has its own
characteristic. For more information, please refer to RFC5465.
To manually create new IAX user, go to web GUI->PBX->Basic/Call Routes->Extensions. Click on
"Create New IAX Extension" and a new dialog window will show for users to fill in the extension
information. The configuration parameters are as follows.
General
Extension
CallerID Number
Permission
SIP/IAX Password
Firmware Version 1.0.10.39
If enabled, SIP Password will accept only alphabet characters and digits.
Auth ID will be changed to the same as Extension.
If enabled, the extension will be added to LDAP Phonebook PBX list.
Enable registration and call from Web RTC.
Specify which Music On Hold class to suggest to the bridged channel
when putting them on hold.
The maximum duration of call-blocking.
Table 34: SIP Extension Configuration Parameters – Specific Time
Click to add Time Condition to configure specific time for this extension.
Table 35: IAX Extension Configuration Parameters – Basic Settings
The extension number associated with the user.
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls using this rule.
Configure the password for the user. A random secure password will be
automatically generated. It is recommended to use this password for
UCM6510 IP PBX User Manual Page 125 of 339