Save And Apply Changes; Make Your First Call; Figure 6: Ucm6510 Web Gui Language; Figure 7: Ucm6510 Web Gui: Apply Changes - Grandstream Networks UCM6510 User Manual

Figure 6: UCM6510 web GUI Language

SAVE AND APPLY CHANGES

Click on "Save" button after configuring the web GUI options in one page. After saving all the changes,
make sure click on "Apply Changes" button on the upper right of the web page to submit all the changes. If
the change requires reboot to take effect, a prompted message will pop up for you to reboot the device.

Figure 7: UCM6510 web GUI: Apply Changes

MAKE YOUR FIRST CALL

Power up the UCM6510 and your SIP end point phone. Connect both devices to the network. Then follow
the steps below to make your first call.
1. Log in the UCM6510 web GUI, go to PBX->Basic/Call Routes->Extensions.
2. Click on "Create New SIP Extension" to create a new extension. You will need User ID, Password and
Voicemail Password information to register and use the extension later.
Firmware Version 1.0.10.39 UCM6510 IP PBX User Manual Page 39 of 339