Batch Add Iax Extensions; Table 44: Batch Add Iax Extension Parameters - Grandstream Networks UCM6510 User Manual

Other Settings
SRTP
Fax Mode
Strategy
Enable T.38 UDPTL
Skip Trunk Auth
Codec Preference

BATCH ADD IAX EXTENSIONS

Under Web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add
IAX Extensions".
General
Start Extension
Firmware Version 1.0.10.39
Enable SRTP for the call. The default setting is "No".
Select Fax mode for this user. The default setting is "None".

None: Disable Fax.

Fax Detect: Fax signal from the user/trunk during the call can be
detected and the received Fax will be sent to the Email address
configured for this extension. If no Email address can be found for the
user, the Fax will be sent to the default Email address configured in
Fax setting page under web UI->PBX->Internal Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
This option controls how the extension can be used on devices within
different types of network.

Allow All
Device in any network can register this extension.

Local Subnet Only
Only the user in specific subnet can register this extension. Up to three
subnet addresses can be specified.

A Specific IP Address.
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
Enable or disable T.38 UDPTL Support.
If enabled, users will not need enter the "PIN Set" required by the outbound
rule to make outbound calls. The default setting is "No".
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, ILBC,
ADPCM, LPC10, H.264, H.263 and H.263p. In the selected codec list,
users can click on UP or DOWN arrow to adjust the order for the codec
priority.

Table 44: Batch Add IAX Extension Parameters

Configure the starting extension number of the batch of extensions to be
added.
UCM6510 IP PBX User Manual Page 137 of 339